Toyota 02-8FGF15 Manuel De L'opérateur page 29

01_A5028-0EA04_En.fm 28 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
(1)
(1) Automatic forks leveling switch
en-28
Forks automatic leveling switch
While pressing the switch and the forks are
operated forward from a backward-tilted posi-
tion, or backward from a forward-tilted posi-
tion, the forks will automatically stop at a
horizontal position. Releasing the switch will
allow for normal tilt lever operation.
Forks forward-tilt automatic leveling control
When the forks are in a backward-tilted posi-
tion, operating the lever forward while press-
ing the automatic forks leveling switch will
automatically stop the forks at a horizontal
position. This function is convenient when
handling loads or attaching/detaching forks.
While pressing the automatic forks leveling
switch, operating the forks forward from a
backward-tilted position:
Not loaded Loaded
High lift Forks stopped at their horizontal No forward tilt
position
(with mast vertically positioned)
Low lift Forks stopped at their horizontal position
(with mast vertically positioned)
Forks backward-tilt automatic leveling control
When the forks are in a forward-tilted position,
operating the lever backward while depressing
the automatic fork leveling switch will auto-
matically stop the forks at a horizontal posi-
tion. This function is convenient when using
clamp-type attachments while the mast is tilted
forward from the vertical position.
While pressing the automatic forks leveling
switch, operating the forks backward from a
forward-tilted position:
Not loaded Loaded
High lift
Forks stopped at their horizontal position
(with mast vertically positioned)
Low lift
Active mast rear tilt speed control
When the mast is raised to a high position,
backward-tilt speed will automatically slow
down.
(1)
(1) Automatic forks leveling switch
Load meter display
In the case of vehicles with multifunction dis-
play DX (Option), pressing the fork automatic
leveling switch will display the weight of the
load being handled.
Note:
• The load meter switch and fork automatic
leveling control switch functions are com-
bined.
• Operate this function when loading is not
being conducted.
• When weighing the load, always remember
to position the load at a height of about
500mm above the ground and make the
mast perpendicular.
Attachment lever
Operates attachment. Attachment speed can be
adjusted by the extent of pressing the accelera-
tor pedal and operating the lever.
Note:
• After the OPS System has been activated,
return the accelerator pedal and all of the
levers to their neutral positions and return
to the seat before recommencing opera-
tions.
• Operate the attachment lever after you are
seated properly in the vehicle.