01_A5028-0EA04_En.fm 49 ページ 2012年12月6日 木曜日 午後12時42分
(1)
(1) Parking brake pedal
(2)
(2) Parking brake release lever
(1)
(1) Inching and brake pedal
Parking brake inspection
1.
Fully press down on the parking brake
pedal and insure that the brake is func-
tioning normally.
2.
After fully pressing the parking brake
pedal, pull the parking brake release lever
toward you and confirm that the parking
brake is released.
Warning
Ask a Toyota dealer for inspection when any
abnormality is found.
Inching and brake pedal inspection
1.
Manually depress the inching and brake
pedal to check the play until a resistance
is felt.
Note:
See the service data section for the value of
inching and brake pedal play.
2.
Depress the inching and brake pedal and
check that there is no destruction or
abnormal resistance.
Caution
Caution
Ask a Toyota dealer for inspection when any
abnormality is found.
(1)
(1) Fuel tank cap
Inspection of OPS lamp
Sit on the seat, start the engine, and check that
the OPS lamp is not lighted.
In the following circumstances, a malfunction
to the OPS system may have occurred. Park
the vehicle at a safe location and contact your
Toyota dealer.
•
The OPS lamp does not light up when the
operator leaves the seat.
•
The OPS lamp does not turn off when the
operator return to the seat.
Instrument inspection
Start the engine and see that they operate prop-
erly.
Fuel level check and supply
1.
Observe the fuel meter to see if the fuel is
sufficient.
Note:
After the end of daily operation, fill the tank
with fuel to prevent the moisture in the air in
the tank from mixing into the fuel.
2.
When supplying fuel, stop the engine,
remove the fuel tank cap by turning it
counterclockwise, and pour fuel through
the fuel filler neck.
3.
After fueling, be sure to tighten the fuel
tank cap.
Caution
Caution
•
Always stop the engine and keep any fire
source away before and during the fuel-
ing operation.
•
Carefully prevent entrance of water and
dirt into the tank during fueling.
en-49
en