Toyota 02-8FGF15 Manuel De L'opérateur page 34

01_A5028-0EA04_En.fm 33 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
Seat belt
To fasten your seat belt, pull it out of the
retractor and insert the tab into the buckle.
You will hear a click when the tab locks into
the buckle. Pull on the belt to make sure the
buckle is securely latched.
The seat belt length automatically adjusts to
your size.
Note:
If your seat belt cannot be pulled out as a
locked status, loosen your seat belt after pull-
ing it out strongly, and then pull it out slowly
again.
Warning
Always wear your seat belt when driving the
vehicle. The vehicle can tip over if operated
improperly.
To protect operators from the risk of serious
injury or death in the event of a tipover, it is
best to be held securely in the seat.
The seat and seat belt will help to keep you
safely within the vehicle and operator's
compartment.
In the event of a tipover, don't jump, grip
the steering wheel, brace your feet, lean
away from the direction of tipover, and stay
with the vehicle.
Warning
Buckle up. Your seat and seat belt can
reduce the risk of serious injury or death in
case of a vehicle tipover. You chances for
avoiding serious injury or death in a tipover
are better if you stay with the vehicle in the
operator's compartment.
Disconnecting method
Push the release button and allow the belt to
retract.
(1)
(5)
(2)
(4)
(3)
(1) Headrest
(2) Seat adjustment lever
(3) Weight adjustment lever
(4) Recliner adjustment lever
(5) Lumbar adjustment knob
Fabric seat (Option)
Caution Caution
• Due to the seat switch, the forklift cannot
be driven and the forks cannot be raised
or lowered unless the operator is sitting
on the seat. Therefore, please sit on the
seat before attempting to operate the
forklift. Moreover, do not operate it with
an object placed on the seat.
• Do not turn on the seat switch by any
method other than sitting on the seat.
Adjusting the pointer on the weight scale to the
operator's weight to obtain the most comfort-
able suspension matching the operator's
weight.
The optimum driving position can be set using
the levers.
1. Headrest
The headrest height can be adjusted by it
sliding up and down.
2. Seat adjustment lever
The seat position can be adjusted either
forward or backward while the adjust
lever is pulled up.
3. Weight adjustment lever
Turn the adjust lever clockwise ((+)
direction) or counterclockwise ((-) direc-
tion) to move the pointer in the direction
toward a heavier or lighter weight,
respectively.
4. Recliner adjustment lever
Pull the lever on the left to adjust the
seat's angle of recline.
5. Lumbar adjustment knob
Use this adjust knob to adjust the lumbar
support. Turning the adjust knob clock-
wise ((+) direction) increases the support-
ing power and counterclockwise ((-)
direction) decreases it.
Warning
• Never adjust your seating position while
the vehicle is moving.
• Always move the seat to the front posi-
tion before opening the engine hood to
prevent interference with the radiator
cover.
en-33
en