Toyota 02-8FGF15 Manuel De L'opérateur page 25

01_A5028-0EA04_En.fm 24 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
(3)
(1)
(2)
(1) Forward tilting
(2) Backward tilting
(3) Tilt lever knob switch
(1)
(1) Tilt lever knob switch
en-24
Tilt lever
Tilts the mast forward and backward.
Forward .................................... Push forward
Backward................................. Pull backward
The forward or backward tilting speed can be
adjusted by the degrees of accelerator pedal
depression and lever operating stroke.
Caution Caution
• Insure the load-handling control levers
are in their neutral positions before
returning to the operator's seat, if not
load-handling functions will start move-
ment 1 second after operator returns to
the seat.
• Always operate the tilt lever from a
seated position.
• After the OPS System operates, return
the accelerator pedal to its fully released
position and the tilt lever to the neutral
position, and sit on the seat to restart the
operation. (If the operator sits on the
seat without returning the load-handling
control levers to their neutral positions,
load-handling functions will start move-
ment 1 second after.)
Tilt lever knob switch
Depressing the tilt lever knob switch while
changing from backward to forward tilt will
automatically stop forks at their horizontal
position.
It is also possible to slow down the backward
tilt speed at a low lift height by depressing
knob switch.
Automatic forks leveling control
With the forks positioned at backward tilt, use
the lever to tilt the forks forward while
depressing the tilt lever knob. Then, the mast
will be automatically stopped with the forks
horizontally positioned.
Motion upon change of tilt from backward to
forward, with tilt lever knob switch pressed:
Not loaded Loaded
High lift Forks stopped at its horizontal No forward tilt
position (with mast vertically
positioned)
Low lift Forks stopped at its horizontal position (with mast
vertically positioned)
Active mast rear tilt speed control
At a high lift height, the mast has a backward
tilt speed controller (slow down) irrespective
of the load. When lowering from a high lift
height to a lower lift height while tilting the
mast backward, the control speed will not
change.
At a low lift height, the mast can be tilted at
full speed even if there is a load. If the mast is
tilted backward at a low lift height with the tilt
knob switch pressed, the mast has the back-
ward tilt speed controlled (slowed down) as
long as the tilt lever knob switch is pressed.
When the fork enters the upper lift height stage
from the lower one, the rear tilt speed will be
restrained as long as the automatic fork level-
ing control switch is depressed. If the switch is
not depressed, the fully open speed will be
applied.