Leica DM R Serie Mode D'emploi page 39

Assembly of photo adapter tubes
Slightly loosen the clamp screw (42.1) on the
side with the 3 mm screwdriver, remove black
cover, place tube on microscope and align
edges parallel to the microscope. Retighten
clamp screw (42.1).
The supplied vertical photo adapter tube (32.2)
can be used instead of the photo adapter tube
with two exits (32.1) on any of the photo tubes.
This is attached by loosening the clamp screw
(31.6) with the 3 mm hexagonal screwdriver and
then retightening.
Eyepiece adapter tube HC,
TV adapter HC
Photo eyepieces and HC TV adapters can be
inserted into the photo adapter tubes.
Make sure you are using the right combination,
depending on the type of eyepiece, photo
system (LD or MPS) and TV chip size!
Phototube Leica DM RD HC
Automatic microscope camera system with
integrated observation tube and 0 – 35° variable
viewing angle, automatic focus compensation,
overlay of measurement field and format
outlines, image erection; also for Pol eyepieces
(field of view index 28 for zoom setting 0.9x);
zoom eyepiece system 0.9x to 2.5x for all exits,
motor-driven; external overlay facility; one addi-
tional exit each for a second 35 mm camera and
a TV camera; intermediate image plane access
for graticules in slide for documentation
purposes; with control electronics (Fig. 33 and
special instructions).
Fig. 33 Leica DM RD HC phototube
39