Leica DM R Serie Mode D'emploi page 14

!
Attention:
Protect movable interior parts with foam rubber
or similar in case of shipment.
To open lamphousing 106 z and 252: undo screws
(5.4) and flip up the lid of the lamphousing. Pull
the cut-out plug slightly out of the socket (6.11).
Fig. 7 Lamp holders for gas discharge lamps*
1 Upper clamp, 2 Seal point of the burner, 3 Lower clamp,
4, 6 Drillholes for fixing the holder, 5 Sockets for cut-out plug,
7 Protective cover
Hg 50
1
2
4
5
6
Hg 100
14
Undo the screws (5.10) on the lamp holder and re-
move the holder (Fig. 7). Remove the spent burner
by loosening the clamp screws (7.1 and 7.3).
Insert burner as follows, adhering strictly to the
above safety information:
Do not remove the protective covering yet (7.7).
3
Hg 100
Stab.
1
3
Xe 75
1
7
3
1
3