T-Pin; Patient Safety Straps; Articulating Arm Board Assembly - Mizuhosi 5943 Manuel Du Propriétaire

2.4 T-Pin

Each Jackson Spinal Surgery Top and Radiolucent Imaging Top is supplied with four (4)
T-pins (see Figure 5). The T-pins are used to connect the H-frames to the crossbars on
the table base and to connect the table tops to the H-frames. Eight (8) T-pins are
required to attach both table tops for a 180 degree patient rotation (see section 8.0:
Rotation Procedures).
Drop lock

2.5 Patient Safety Straps

The Jackson Spinal Surgery Top is supplied with six (6) patient safety straps; four (4)
90" straps, one (1) 60" strap, and one (1) buttock strap (see Figure 6). When a patient
is positioned on the Jackson Spinal Surgery Top or Radiolucent Imaging Top, verify that
the appropriate patient safety straps are applied and secured as described in section
7.0 of this owner's manual.

2.6 Articulating Arm Board Assembly

The Jackson Spinal Surgery Top is supplied with two (2) articulating arm boards and
mounting brackets (see Figure 7). These arm boards may be attached directly to the
spinal top at any location along the length of the frame. The articulating arm board is
adjustable in six directions as shown by the arrows in Figure 7.
Figure 7: Articulating arm board for the Jackson Spinal Surgery Top
MIZUHOSI 2009
Figure 6: Jackson Spinal Surgery Top patient safety straps
Armboard
assembly
Figure 5: T-pin
9
Buttock strap
60"
90"
Mounting
bracket
NW0504 Rev. D