Mizuhosi 5943 Manuel Du Propriétaire page 43

T-pin coupling
imaging top to
H-frame
T-Pin coupling the
upper
H-frame to
crossbar
Crossbar
Lower
H-frame
Make certain to remove only the T-pin at the head end that couples the imaging
top to the upper H-frame. Removing the wrong T-pin will result in the patient
being dropped.
NOTE: The anesthesiologist may now reconnect the patient circuit, monitors and IV
lines as necessary.
8.9.3 Attach the arm board mounting brackets and articulating arm boards at the
8.9.4 Carefully free the patient's arms and position the arms on the arm boards;
8.9.5 Pad and secure the arms onto the arm boards with the TLC arm cradles
8.9.6 With one person holding each end of the Radiolucent Imaging Top, the
Verify that the four (4) T-pins holding the Jackson Spinal Surgery Top and the H-
frames to the crossbar are in place and secure before removing the safety straps.
Failure to do so may result in the patient being dropped.
MIZUHOSI 2009
Figure 51: Head end
(T-pin identification)
desired locations on the spinal top.
the chest pad safety strap may be removed if necessary.
and contact closure straps provided in the patient care kit.
attendant may remove the remaining safety straps that surround both
table tops.
Figure 52: Foot end
(T-pin identification)
Warning:
Warning:
43
T-pin coupling
imaging top to
H-frame
T-Pin coupling the
Upper
H-frame to
crossbar
Crossbar
Lower
H-frame
NW0504 Rev. D