Radiolucent Imaging Top; H-Frame - Mizuhosi 5943 Manuel Du Propriétaire

2.2 Radiolucent Imaging Top

The Radiolucent Imaging Top is 21.5" (54.6 cm) wide, 84" (213 cm) long, made from a
carbon composite material and has a patient weight limit of 500 pounds (226 kg). Each
Radiolucent Imaging Top is labeled to indicate its patient weight limit. The imaging top
is radiolucent including views through the radiolucent side rails. It includes a 2" thick
Mizuho OSI Tempur-Med® table pad and two (2) side rail mounted safety straps.
HEAD END

H-frame

Figure 3: Radiolucent Imaging Top component identification
(The table top is shown coupled to the 5803 Advanced Control Modular Table System Base)
NOTE: Mizuho OSI P/N 5855-830 side rail adapters must always be used to attach
these types of devices to the table to prevent damage. If retractors, clark sockets, arm
boards or other accessories are attached directly to the side rail of the radiolucent
imaging top, they may cause damage in the form of cracking or splintering of the carbon
fiber table top. Please see section 3.0 in this owner's manual for more information
related to the use of the Radiolucent Imaging Top.
2.3 H-Frame
Each Jackson Spinal Surgery Top and Radiolucent Imaging Top is supplied with two (2)
H-frames (see Figure 4). The H-frames are used to connect the table tops to the base
with T-pins. Four (4) H-frames are required to attach both table tops for a 180 degree
patient rotation (see section 8.0: Rotation Procedures).
MIZUHOSI 2009
Table pad
Safety strap (2)
Figure 4: H-Frame
8
FOOT END
H-frame
Radiolucent
imaging top
NW0504 Rev. D