Porsche Mobile Charger Plus Mode D'emploi page 35

Light indicators
The CHARGE STATUS button lights up red.
The VEHICLE light indicator flashes yellow.
The CHARGE STATUS button lights up red.
The CHARGER light indicator lights up yellow.
The CHARGE STATUS button lights up red.
The CHARGER light indicator flashes yellow.
The CHARGE STATUS button pulses green.
The HOUSE CONNECTION light indicator lights
up yellow.
The CHARGE STATUS button pulses green.
The CHARGER light indicator lights up yellow.
On/Off pulses green.
Power grid/house connection lights up yellow.
Vehicle lights up yellow.
The charger has shut down completely.
Meaning
Invalid CP signal
High temperature
Unable to read the infrastructure cable or vehicle
cable
Excess temperature of infrastructure plug/Multi-
phase socket only has a single-phase connection
Derating
The vehicle is charged with deactivated protective
conductor monitoring.
Remedy
e
Pull out and reinsert the power plug.
e
The charger has switched off due to a high tem-
perature. Wait. If applicable, protect the charger
from direct sunlight.
e
Pull out and reinsert the power plug.
e
The charger has reduced the charging power
due to a high temperature. Wait. If applicable,
protect the charger from direct sunlight.
e
A multi-phase socket may have only a single-
phase connection. In this case, have a qualified
electrician check whether the electrical socket is
correctly connected in the power grid.
e
The charger has reduced the charging power
due to a high temperature. Wait. If applicable,
protect the charger from direct sunlight.
e
Ideally, charge the vehicle with activated protec-
tive conductor monitoring.
g Refer to chapter "Ground monitoring" on
page 25.
e
The charger is in standby mode or has shut
down due to an error.
e
Press the charging current limiting button to
check whether the charger is in standby mode.
Malfunctions
33