Porsche Mobile Charger Plus Mode D'emploi page 21

In some countries, e.g. Norway , the supply cable
1
must only be changed by a qualified electrician. Por-
sche recommends that you use a certified Porsche
service partner.
Fig. 12 Connections on the control unit
The supply cable is removed and plugged in at the
A
top of the control unit.
The vehicle cable is securely connected to the
B.
control unit.
1. Time of printing.
Disconnecting the supply cable
Fig. 13 Disconnecting the supply cable
b Charging of the high-voltage battery has ended
and the vehicle plug has been removed from the
vehicle charge port.
b The plug has been disconnected from the elec-
trical socket.
1. Remove screw (Fig. 13) using a suitable tool.
C
2. Fully open the cover (Fig. 13).
A
3. Pull out the plug (Fig. 13) until resistance is
B
first felt.
4. Close the cover (Fig. 13) to about 15 de-
A
grees (the cover can be in contact with plug
(Fig. 13)).
5. Pull out the plug (Fig. 13) fully.
B
Securing the supply cable
Fig. 14 Securing supply cables and plugs
1. Open the cover (Fig. 14) by about 15 degrees
A
(just far enough so that the plug
in the control unit).
2. Insert the plug (Fig. 14) into the control unit
B
until resistance is first felt.
3. Fully open the cover (Fig. 14).
A
4. Push in the plug (Fig. 14) fully.
B
5. Close the cover (Fig. 14) fully and fasten with
A
screw (Fig. 14).
C
B
Setup
(Fig. 14) fits
B
19