Charging Your Stimulator - Boston Scientific Precision SC-5213 Manuel D'utilisation

Charging Your Stimulator

1. When the indicator light is green, remove the Charger from the Base Station. (The indicator will go off, regardless of the ready
status of the Charger.)
2. Using the Adhesive Patch:
• Apply the adhesive patch to the backside of the Charger by peeling the clear
liner from the patch and applying the white side with the blue stripe to the rear of
the Charger, as shown. (See diagram right.)
• Remove the skin side beige liner from the adhesive (only good for one fixation).
(See diagram right.)
OR
Using the Charger Belt:
• Place the Charger into the pocket on the Charger Belt with the power button
facing out. (See diagram right.)
3. Press the power button. The indicator light will come on again, and the Charger will begin beeping steadily to signal that it is
searching for the Stimulator.
4. Locate the Charger over the Stimulator. When the Charger is aligned with the
Stimulator, the beeping will stop.
Charging the Stimulator
Patient System Handbook
90868426-08 REV A 33 of 213