Charging Your Stimulator - Boston Scientific SC-6412 SCS Charger 2.0 System Kit Mode D'emploi

Charging Your Stimulator

1. When the indicator light is green, remove the Charger from the Base Station. (The indicator
will go off, regardless of the ready status of the Charger.)
2. Refer to The Charger Belt section of this handbook for instructions on preparing the belt for
charging.
OR
If using Adhesive Patches:
• Apply the adhesive patch to the backside of the Charger by peeling the clear liner
from the patch and applying the white side with the blue stripe to the rear of the
Charger.
• Remove the skin side beige liner from the adhesive (only good for one fixation).
3. Press the power button. The indicator light will come on again, and the Charger will begin
beeping steadily to signal that it is searching for the Stimulator.
Charging the Stimulator
Charger Handbook
90970865-13 REV A 9 of 75