The Remote Control
If the stimulation gauge is full and the up arrow disappears you have reached the maximum allowable level and can only decrease the
stimulation setting. If the stimulation gauge is empty and the down arrow disappears you have reached the minimum level and can
only increase the stimulation setting.
Selecting Areas for Level Control
Note: Only applicable if your Stimulator is programmed to treat more than one area and to operate at frequencies of 1,200Hz or
below.
Your Remote Control may have as many as four therapy areas stored for your use. Each area will have a name or a number
(1 through 4) which was assigned during your programming at the clinic. The stimulation level for each of these areas is controlled
from an individual "area level" screen. To change the stimulation strength of a single area:
1. From the main Level screen, press the
button as many times as necessary to cycle through your programmed area Level
"
screens.
Patient System Handbook
90868426-08 REV A 17 of 213