Communicating With The Stimulator - Boston Scientific Precision SC-5213 Manuel D'utilisation

Precision™ SCS System with MultiWave Technology Patient System Handbook
P P
To unlock the Remote Control, press and hold , until "Release To Unlock" appears. The Remote Control will immediately look for
your Stimulator and then connect with it, allowing you to make adjustments to your stimulation.
When you are finished using it (no buttons are being pressed), the Remote Control will return to the sleep mode within a minute or so.

Communicating with the Stimulator

Good communication between your Stimulator and the Remote Control is very important. For that reason, you will sometimes see the
following icon on your screen. This indicates that the Remote Control is checking for the Stimulator.
Note: If there is a problem communicating with the Stimulator, the message "No Response" will appear on the Remote Control
P
screen. Press to retry, or press to cancel. See "Help" on page 35 for more information.
"
Patient System Handbook
90868426-08 REV A 12 of 213