Battery Replacement - Boston Scientific Precision SC-5213 Manuel D'utilisation

Precision™ SCS System with MultiWave Technology Patient System Handbook
Next, you would see the more urgent message shown below. You must respond immediately! When you press
will make another check of your Stimulator battery and may display one of the messages shown below.
Note: Make a habit of replacing the Remote Control batteries when you first see the Remote Battery Low message. See "Battery
Replacement" below.

Battery Replacement

1. On the rear of the Remote Control, push in slightly and slide down the battery
compartment cover.
2. Remove the old batteries.
3. Place the three new AAA batteries in the slots, matching the positive (+) and
negative (–) markings in the compartment.
4. Align the battery compartment cover on the case and slide the cover into position
until it snaps closed.
The Remote Control will connect to the Stimulator in approximately 30 seconds.
Note: It is recommended that you remove the batteries if the Remote Control is not
going to be used for an extended period of time.
Patient System Handbook
90868426-08 REV A 28 of 213
P
, the Remote Control