Battery Replacement - Boston Scientific SC-5210 Manuel

Patient System Handbook
• If the Stimulator battery is very low, the Remote Control will display this notice to recharge the stimulator battery immediately.
Stimulation has most likely been turned off automatically.
Note: The Remote Control will continue to display this message until the stimulator is recharged.

Battery Replacement

1. On the rear of the Remote Control, push in slightly and slide down the battery
compartment cover.
2. Remove the old batteries.
3. Place the three new AAA batteries in the slots, matching the positive (+) and
negative (–) markings in the compartment.
4. Align the battery compartment cover on the case and slide the cover into
position until it snaps closed.
The Remote Control will connect to the Stimulator in approximately 30 seconds.
Note: It is recommended that you remove the batteries if the Remote Control is not going to be used for an extended period of time.
Patient System Handbook
9055960-003 REV B 28 of 233