Pulse Output; Relays - Burkert 8025 Notice D'utilisation

4 CONFIGURATION
ENTER
CURRENT
PULSE

4.3.5 Pulse output

The pulse output is available on the open collector transistor. In this menu, the parameters
of the pulse output are defined and the flow rate, that shall correspond to one pulse is
determined.
First enter the unit, then the value. Example: 1 pulse corresponds to 5 m3.
ENTER
PULSE
FILTER
4.3.6 Relay
The parameter definition of the limit contacts is done in this menu. Two limit values are en-
tered for each relay ; 1- and 1+ or 2- and 2+. The user also has the possibility to invert the
relays. The unit and decimal place, as selected in the sub-menu "UNIT" are activated.
The following condition must be observed: 1-
FLOW TRANSMITTER 8025
4 = 0000
Entering the beginning of the meas-
uring range
0......9
ENTER
4 = 0000
ENTER
L
ENTER
M3
USGAL
IMPGAL
≤
1+, 2-
E-36-
20 = 0000
Entering the end of the
measuring range
0......9
20 = 0180
PU = 000.00
Input of the quantity
corresponding to one
0......9
pulse
ENTER
PU = 005.00
≤
2+.