Burkert 8025 Notice D'utilisation page 74

3 INSTALLATION
3.3.11 Connecting the flow sensor to transmitter 8025 in separate
versions
Connect the remote flow sensor to the "FLOW SENSOR" connector of the electronic
board, by respecting the pin assignment according to the output type of the remote sensor,
either sinus output (COIL) or pulse output (NPN). First of all, correctly configure the switch
on the electronic board (see § 3.3.4).
Shielding of the sensor cable
NC
1 2 3 4 PE
Sensor with a sinus output
NC = Not connected
3.3.12 Allocation of the cable glands of the wall-mounted versions
Pass the cables through the cable glands by preferably respecting the following allocation
in order to ease the wiring:
Flow sensor
cable
Fig. 3.16
Allocation of the cable glands, wall-mounted versions
FLOW TRANSMITTER 8025
NC
1 2 3 4 PE
Sensor with a pulse output (NPN)
Outputs cables
E-26-
Pulse NPN
V-
V+
Shielding of the sensor cable
12-30 VDC or
115/230 VAC
power supply cables