Installation; Compact Version; Panel-Mounted Version - Burkert 8025 Notice D'utilisation

3 INSTALLATION

3.2 Installation
3.2.1 Compact version (fig. 3.2)
The compact flow transmitter 8025 can be
easily installed into pipes using our specially
designed fitting system.
1. The fitting "5" must be installed into the
pipe according to the installation specifica-
tions in section 3.1.
2. Insert plastic nut "3" into fitting and let
plastic ring "2" snap into guide bush "4".
3. Carefully insert transmitter 8025 "1"
into fitting. If installed properly, the transmit-
ter cannot be rotated.
4. Tighten transmitter housing to fitting
with plastic nut "3".
Plastic nut must only be tight-
ened by hand!
3.2.2 Panel-mounted version (fig. 3.3)
Respect the installation specifications described in section 3.1and follow the instructions
below to install the device:
1. Use the supplied drilling jig to cut away the necessary opening in the panel. Make sure
to scrupulously respect the dimensions indicated.
2. Place the gasket on the 4 screws of the cover.
Note: Use the 4 M4x25 screws supplied if the panel door is too thick.
3. Place the cover+gasket set on the cut-away with the electronic board facing the inside
of the panel.
4. Insert the 4 washers onto the 4 screws and fit the device to the panel using the 4 nuts.
5. Connect according to instructions described in chapter 3.3.
6. Use the supplied 4 cable clips to fit the cables to the protective plate.
FLOW TRANSMITTER 8025
Fig. 3.2
Mounting, 8025, compact version
E-10-