Servo Direction Setting "Reverse - ModelCraft FS-T6 Notice D'emploi

a) Servo Direction Setting "Reverse"
Depending on the position of the servos, a control movement to the left on the transmitter may invoke a steering
movement to the right. This is why the transmitter allows you to individually set and save the rotting or running direction
of every individual servo.
Adjusting the Servo Running Directions
• Switch on the transmitter and call the function setting menu. The top menu
item "Reverse" is marked by the cursor arrow.
• Briefly confirm the scroll wheel button or the button "OK" to activate the
menu item.
In the display you will see display items for the six control channels with the
respective running directions. "Nor" corresponds to the standard running
direction of the servo and "Rev" to the reversed running direction.
• Turn the scroll wheel to change the rotating direction of the servo at
channel 1.
• When pushing the scroll wheel button, the cursor arrow will jump to
channel 2.
• Turn the scroll wheel to change the rotating direction of the servo at
channel 2.
• Repeat his process until you have set the correct running direction of the
servos in all six channels.
• Push the button "OK" to save the settings. The display then shows the
function setup menu again.
• Push the button "CANCEL" repeatedly until you return to the operating
display and check if all servos have the correct running direction.
92
Figure 28