Binding Function - ModelCraft FS-T6 Notice D'emploi



16. Binding Function

Transmitter and receiver are already aligned with each other and can be used at once. Binding only needs to be
performed again after replacing the transmitter or receiver or to remove malfunctions.
Since other manufacturers use different encoding and decoding methods, transmitter and receiver cannot be combined
and operated with products of other companies.
Re-establishing the binding:
To recover binding between the transmitter and receiver, the binding plug (1) must be connected at the connection
"BAT" of the receiver. The receiver power supply (2) can be connected to any output CH1 - CH6. The receiver and the
remote control transmitter must be in direct proximity (max. 1 m distance).
• Switch on the receiver power supply. The LED (3) in the receiver
is flashing and thus indicates the binding mode.
• Push and hold the binding key (4) at the transmitter and switch
on the transmitter with the on/off switch.
• The LED (3) in the receiver is lit and thus indicates the successful
binding of the transmitter and receiver.
• Switch off the power supply of the receiver and disconnect the
binding plug.
• Switch off the transmitter.
• Connect all servos to the receiver and connect the power supply
of the receiver to the connection "BAT" again.
• Check the function of the receiver system and the servos.
Binding is now completed and the receiver or the servos now need to react to the control signals of the
transmitter again. If this is not the case, repeat binding.
114
Figure 48