Encoder Assignment "Aux. Channels - ModelCraft FS-T6 Notice D'emploi

d) Encoder Assignment "Aux. channels"
For the encoder assignment, you can set individual encoders for channels 5 and 6 (rotary encoder or toggle switch).
If you have any swash plate mixer or variable pitch control activated in the system setting menu, channel
6 is needed for rotor head linkage and therefore cannot be freely assigned. Channel 6 shows the display
"Source Used" (also see bottom-most figure 31).
Setting Encoder Assignment
• Switch on the transmitter and call the function setting menu.
• Move the cursor arrow to the menu item "Aux. channels" with the scroll
wheel.
• Briefly confirm the scroll wheel button or the button "OK" to activate the
menu item.
The display shows channels 5 and 6 in the respective assigned encoders
"Source". The two cursor arrows at channel 5 show that the encoder can be
set at once in this channel.
• Turning the scroll wheel now permits selection of the encoder. In addition
to the four toggle switches "SwA - SwD" and the two rotary encoders
"VrA" and "VrB", the value "None" can be selected as well when channel
5 is, e.g., not to be controlled manually but only via a mixer.
• When pushing the scroll wheel button, the cursor arrows will jump to
channel 6.
• Turning the scroll wheel now permits selection of the encoder for channel
6.
• Push the button "OK" to save the settings. The display then shows the
function setup menu again.
• Push the button "CANCEL" repeatedly until you get back to the operating
display.
Figure 31
95