Pitch Curve Setting "Pitch Curve - ModelCraft FS-T6 Notice D'emploi

h) Pitch Curve Setting "Pitch Curve"
This menu is only available if a helicopter with variable pitch function or swash 90°, 120° or 140° was
selected in the system settings menu!
Just like the throttle curve, the pitch curve can be individually set in all five points. It is no matter whether you are using
a model with only one pitch servo or the swash plate is controlled by three servos at once.
Setting the pitch curve
• Switch on the transmitter and call the function setting menu.
• Move the cursor arrow to the menu item "Pitch Curve" with the scroll wheel.
• Briefly confirm the scroll wheel button or the button "OK" to activate the
menu item.
The display shows the indications for the percentage setting values for the
five points of the pitch curve (L, 1, 2, 3 and H), the control curve chart and
the flight condition "Normal".
The vertical dash in the chart marks the position of the pitch control stick.
In flight condition "Normal", the values of the pitch curve should be reduced
a little to keep the curve flatter. The model helicopter will thus be controllable
more easily and delicately in hover flight this way.
• Turning the scroll wheel selects the percentage input value for the bottom
point of the pitch curve in the flight condition "normal".
• When pushing the scroll wheel button, the cursor arrow will jump to the
pitch curve setting point "1". Turning the scroll wheel now permits setting
the percentage input value for this point.
• Repeat this process until you have set the desired value for the flight
condition "Normal" in all five points.
• Now operate the toggle switch "SWB" to call the flight condition "Idle up".
On demand, another toggle switch for switching the flight
conditions can be assigned in the following menu switch
assignment menu (Switches assign).
In the flight condition "Idle up", the pitch curve should be set so
that the rotor blades reach the maximum positive and negative
angle of attack.
100
Figure 36