ModelCraft FS-T6 Notice D'emploi page 84

f) Operation as Teaching Transmitter "Trainer mode"
For safe and comfortable model flight training, the remote control system offers a plug-in socket for a trainer-student
cable (see figure 2, item 23). An optional cable permits connecting a second remote control type "FS-T6" to your
transmitter. One remote control then has to be configured as trainer transmitter, and the other one as student transmitter
(see next menu item). The flight trainer can use a freely selectable toggle switch to switch between the control stick
signals of the trainer and student transmitter.
Configuration as trainer transmitter:
• Switch on the transmitter and call the system setting menu.
• Move the cursor arrow to the menu item "Trainer mode" with the scroll
wheel.
• Briefly confirm the scroll wheel button or the button "OK" to activate the
menu item.
The display shows the indication "Mode", "Switch" and, depending on the
trainer/student switch "Engaged" (connected to the student transmitter) or
"not engaged" (not connected).
• Turn the scroll wheel to select whether to activate the trainer function and
the transmitter ("ON") or to deactivate it ("OFF").
• Briefly push the scroll wheel button to switch to the switch selection.
• Turn the scroll wheel to select the switch to use to switch between teacher
and student transmitter. Then confirm the selected switch and check if the
display changes between "Engaged" and "Not engaged".
• Push the button "OK" to save the settings. The display then shows the
system setup menu again.
• Push the button "CANCEL" repeatedly until you return to the operating
display and check if the correct figure is displayed.
84
Figure 20