Mixer Programming "Mix - ModelCraft FS-T6 Notice D'emploi

j) Mixer Programming "Mix"
This programing permits controlling a slave channel via a master channel. The slave channel is taken along linearly,
with the two deflection directions and the deflection values of the slave servo, as well as the working point of the mixer
being programmable individually. All in all, 3 freely programmable linear mixers "Mix #1" - "Mix #3") are available.
Adjusting the Mixers
• Switch on the transmitter and call the function setting menu.
• Move the cursor arrow to the menu item "Mix" with the scroll wheel.
• Briefly confirm the scroll wheel button or the button "OK" to activate the
menu item.
The display shows the indication for mixer #1 with the pre-set mixing values.
• Turning the scroll wheel now permits selection of the desired mixer
"Mix #1" - "Mix #3".
• When pushing the scroll wheel button, the cursor arrow will jump to the
mixer function. Turning the scroll wheel can activate ("On") or deactivate
("Off") the mixing function.
• When pushing the scroll wheel button again, the cursor arrow will jump to
the master channel. Turning the scroll wheel now permits selection of the
master channel.
• When pushing the scroll wheel button again, the cursor arrow will switch
to the slave channel. Turning the scroll wheel permits selection of the
slave channel.
Figure 38
103