Adjusting The Angle Of Inclination Of The Els Kiln Floor - Rohde ELS-N Manuel D'utilisation Original

6.2.5.

Adjusting the angle of inclination of the ELS kiln floor

The angle of inclination of the ELS kiln floor can also be fine-tuned after it has been attached to the floor or on very
uneven floors.
⇒
This activity is usually not required because the floor at the operating location should be prepared accordingly.
Step Description
1
Put a spirit level on the kiln floor.
2 Loosen the bolts of the bearing on the lower guide roller.
3 There is an elongated hole behind the bearing for adjusting
the bearing position.
4 Loosen the locknut of the adjusting screw.
5 The position of the bearing unit is changed by turning the
screw in or out.
Remark
Tool:
Spirit level
Tool:
Loosen the bolts by a maximum of 2-3
turns.
Factory setting = middle position
Tool:
Spanner
Tool:
Spanner
92 / 492 - EN -
• Spanner or socket wrench
• Allen key