Loading The Els Kiln Floor - Rohde ELS-N Manuel D'utilisation Original

Step Description
1 Open the kiln door.
Pull the locking brake handle.
2
3 Hold down the handle to move the ELS kiln floor.
4 To stop, let go of the handle.
The ELS kiln floor can be stopped in any position and is fixed
5
in its position with the locking brake.
The so-called Comfort Stop gently applies brakes to the ELS
6
kiln floor shortly before it reaches the end position.
Table 22: Moving the ELS
8.9.

Loading the ELS kiln floor

WARNING
Risk of serious personal injury or property damage:
⇒
⇒
WARNING
Risk of serious personal injury or property damage:
⇒
⇒
WARNING
Risk serious personal injury or property damage due to overloading of the ELS kiln floor.
⇒
⇒
Please note the information on loading the ELS kiln floor in the following section!
Incorrectly stacked and falling ware can cause injuries or damage to the kiln or
personnel.
The manufacturer assumes no liability for personal injury or property damage.
Never suddenly release the parking brake while moving the ELS kiln floor and never use
the locking brake to stop the floor while it is moving.
If the locking brake is suddenly released, there is a high risk of goods tipping over or
falling onto the ELS kiln floor.
Never exceed the maximum load weight of 40 kg per 100 litres of kiln volume!
104 / 492 - EN -
Remark
Make sure that the kiln door is always
fully open (opening angle of the kiln door
= at least 90° or greater).
Never suddenly release the locking brake
while the kiln floor is being extended and
retracted.
There is a risk that the stacked ware
could fall over!
The pressed handle releases the locking
brake and allows the floor to move.
Letting go of the handle activates the
locking brake and the ELS kiln floor
stops.
Comfort Stop consists of 2
hydropneumatic dampers.
⇒
Comfort Stop is set at the factory
and does not need to be
readjusted during operation.