Control Unit Operation; Opening & Closing The Kiln Door - Rohde ELS-N Manuel D'utilisation Original

8.6.

Control unit operation

TC 304
Figure 13: Supplied control systems (standard)
Optionally, the kiln can also be equipped with type ST 411 and ST 630/ST 632 control systems.
Figure 14: Supplied control systems (optional)
8.7. Opening & closing the kiln door
WARNING
Risk of serious personal injury or property damage:
⇒
⇒
⇒
⇒
⇒
The kiln is supplied ready for operation by the manufacturer with
the preconfigured TC 304 or TC 504 control unit, including the
necessary program and controller settings.
TC 507
Only the machine operator is allowed to be near the kiln while the door is being opened
and closed.
Always open the kiln door fully.
Unauthorised persons are not permitted in the work area.
The operating personnel must wear suitable protective clothing.
The manufacturer assumes no liability for personal injury or property damage.
102 / 492 - EN -
WARNING
An incorrectly placed control unit can lead to
serious personal injury or property damage.
⇒ Make sure that the control system is
never placed on the kiln, but only
positioned in the bracket provided for it.
⇒ It is essential that you first read the relevant instruction
manual for the control system carefully!
The optionally available control systems are also
delivered ready for operation including the necessary
program and controller settings.
⇒
It is essential that you first read the relevant
instruction manual for the control unit
carefully!