Position Of Electrical Connections Of The Heating Elements - Rohde ELS-N Manuel D'utilisation Original

13.10.4. Position of electrical connections of the heating elements

Position
Kiln casing:
Back wall
Kiln door
Kiln floor
Table 37: Position of connections for heating elements
Description
A cover plate is located on the
back wall of the kiln, which
covers the electrical
connections of the heating
elements.
To remove the cover, 2
screws must be removed.
The cover must then be
pushed up and can then be
removed from the front.
Depending on the design, this
cover can be divided into two
parts. In this case, both covers
must be opened and removed
separately.
There is a grill plate on the kiln
door, which covers the
electrical connections of the
heating elements.
To remove the cover, a screw
must be loosened, 2-3 turns.
The cover must then be
pushed up and can then be
removed from the front.
Below the ELS kiln floor, there
is a grill plate that covers the
electrical connections of the
heating elements.
The kiln floor must be fully
extended.
To remove the cover, 2
screws must be removed.
The cover must then be
pushed forward and can then
be removed downwards.
131 / 492 - EN -
Remark
Tool:
Use appropriate tools for the
fastening material.
Store the fastening material
in a safe place.
Tip: Loosely screw the
fastening material back into
the corresponding thread for
storage.
Note:
Pay attention to a possible
grounding cable attached to
the cover.
Tool:
Use appropriate tools for the
fastening material.
Store the fastening material
in a safe place.
Tip: Loosely screw the
fastening material back into
the corresponding thread for
storage.
Note:
Pay attention to a possible
grounding cable attached to
the cover.
Tool:
Use appropriate tools for the
fastening material.
Store the fastening material
in a safe place.
Tip:
Loosely screw the fastening
material back into the
corresponding thread for
storage.
Note:
Pay attention to a possible
grounding cable attached to
the cover.