Scheppach DP3000 Traduction Des Instructions D'origine page 26

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope you have a lot of fun and success using your
new machine.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• improper handling,
• noncompliance of the operating instructions,
• repairs by third parties, not by authorized service
technicians,
• installation and replacement of non-original spare
parts,
• non-intended use,
We recommend:
that you read through the entire operating instruc-
tions before putting the machine into operation.
These operating instructions are to assist you in get-
ting to know your machine and utilize its proper ap-
plications. The operating instructions contain impor-
tant notes on how you work with the machine safely,
expertly, and economically, and how you can avoid
hazards, save repair costs, reduce downtime and in-
crease the reliability and service life of the machine.
In addition to the safety requirements contained in
these operating instructions, you must be careful to
observe your country's applicable regulations.
The operating instructions must always be near the
machine. Put them in a plastic folder to protect them
from dirt and humidity. They must be read by every
operator before beginning work and observed con-
scientiously. Only persons who have been trained in
the use of the machine and have been informed of
the various dangers may work with the machine. The
required minimum age must be observed. In addition
to the safety requirements in these operating instruc-
tions and your country's applicable regulations, you
should observe the generally recognized technical
rules concerning the operation of identical machines.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
26 | GB
2. Device description (Fig. 1-20)
1. Throttle
2. Engine switch
3. Right steering lever
4. Clutch lever
5. Left steering lever
6. Fixation dump box
7. Gear selection lever
7a Switch plate
8. Transport tray
9. Gearbox
10. Wheel
Engine components
11. Throttle
12. Exhaust pipe
13. Spark plug
14. Air filter
15. Petrol valve
16. Choke lever
17. Reverse starter
18. Pull cable starter
19. Fastening screw service port
20. Tank cover cap
21. Fuel tank
22. Oil drain screw engine oil
23. Oil filling opening / oil dipstick
24. Drive chain
25. Spark plug connector
26. Adjusting device
27. Counter nut
28. Oil drain screw transmission oil
29. Oil filling nozzle transmission oil
3. Scope of delivery
• Dumper DP3000
• Steering rod
• Transport tray
• Wheels
• Shift lever
• Plastic bag with mounting material
• Manual,
• Motor manual
4. Intended Use
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
The equipment is to be operated only with suitable saw
blades. It is prohibited to use any type of cutting-off wheel.
To use the equipment properly you must also observe
the safety information, the assembly instructions and
the operating instructions to be found in this manual.
www.scheppach.com