Asa Network; Angle Reading Error; Aligning Cars With Large Track Differences; Aligning Procedure Count - Corghi Exact 70 Manuel D'utilisation

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
The toe curve checking and adjustment sequence
depends on the type of suspension installed on
the car: there are differences for cars with STAND-
ARD, SPORTS or ALL-TERRAIN chassis. Follow the
instructions on the screen for the operations to be
performed and the adapters to be fitted on the
checking tool.

ASA NETworK

To enable use of the Asa Network protocol, set up
the aligner after accessing the technical services
set-up function
Then set the "Procedure" / "Asa Network Procedure"
option as "enabled".
when the aligner software is run, it automatically
checks the network connection, and the connection
icon appears in the windows status bar.
Operation
After starting the alignment procedure,
this system enters the screen for selection of the
working order for processing.
If the network connection is not established, a
dialogue window asks whether you wish to return
the connection,
of the vehicle from the databank without connect-
ing, .
Once the order has been selected, the working data
are loaded in the form, after which the vehicle has to
be selected from the databank in the usual way.
The alignment procedure which follows is the
usual one.
The , or
used to print, and to save
if you wish.
ends the session and sends the notification
that the order has been processed, and the attached
.XML file containing the data of the job done to the
Network Manager.

ANGLE rEADING Error

Operator's Manual EXACT 70
, and
,or move on to selection
icons can be
the job done
http://www.eichstaedt-elektonik.de
During the working procedures, the beams of the
CCD angle sensors may be interrupted. This occur-
rence is signalled by the connection failure symbol
(Fig.46) which also indicates which beam has been
interrupted.
The angles which cannot be calculated without the
interrupted beams disappear from the adjustment
screens, while the other angles are correct and can
be used for adjustment.
ALIGNING CArS
wITH LArGE TrACK
DIFFErENCES
.
The "High output" mode, and icons, allows wheel
alignment to be performed even on cars with high
track differences (sports cars such as Porsche mod-
els). If this setting is not used, "Link Error" problems
serious enough to make the job impossible may
occur both during adjustment and during the steer-
ing lock procedure.
The "High output" mode is indicated by the sym-
bol in the status bar and is maintained for just
one job.
,
ALIGNING ProCEDUrE
CoUNT
The equipment now features a count of the number
of alignment jobs performed. The count increases
after performance of the ROC procedure, including
ROC skip.
To display the count, select the
and icons from the initial screen.

USEr FILE BACKUP

From the logo page, select the icons
, fig.58.
The page shown in fig.59 will open, allowing you
to select the backup or restore procedure of the
,
EN
and
81