Publicité
FUSE INSPECTION (TT-R90E)
2
1
6. Install:
• Battery
7. Check:
• Battery terminals
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
8. Lubricate:
• Battery terminal
Recommended lubricant:
Lithium soap base grease
9. Connect:
• Battery lead coupler
(to the battery terminals)
10. Install:
• Rear fender
• Seat
FUSE INSPECTION (TT-R90E)
CAUTION:
To avoid a short circuit, always set the
main switch to "OFF" when checking or
replacing a fuse.
1. Remove:
• Seat
• Rear fender
2. Check:
• Continuity
Checking steps:
• Remove the fuse 1.
• Connect the pocket tester to the fuse and
check the continuity.
NOTE:
Set the pocket tester selector to "Ω × 1".
Pocket tester:
YU-03112-C/90890-03112
• If the pocket tester indicates "∞", replace
the fuse.
2 Reserve fuse
3 - 30
INSP
ADJ
Publicité
