Publicité
TIRE PRESSURE CHECK/
SPOKES INSPECTION AND TIGHTENING
6. Install:
• Rear shock absorber
Refer to "SWINGARM" section in the
CHAPTER 5.
EC36Q000
TIRE PRESSURE CHECK
1. Measure:
• Tire pressure
Out of specification → Adjust.
Standard tire pressure:
100 kPa (1.00 kgf/cm
NOTE:
• Check the tire while it is cold.
• Loose bead stoppers allow the tire to slip off
its position on the rim when the tire pressure
is low.
• A tilted tire valve stem indicates that the tire
slips off its position on the rim.
• If the tire valve stem is found tilted, the tire is
considered to be slipping off its position. Cor-
rect the tire position.
SPOKES INSPECTION AND TIGHTENING
1. Inspect:
• Spokes 1
Bend/damage → Replace.
Loose spoke → Retighten.
2. Tighten:
• Spokes
NOTE:
Be sure to retighten these spokes before and
after break-in. After a practice or a race check
spokes for looseness.
3 - 17
INSP
ADJ
2
, 14.5 psi)
2 Nm (0.2 m · kg, 1.4 ft · lb)
Publicité
