Adjusting The Intermediate Position System (Ip); Adjusting The Intermediate Position 70° - 90; Adjusting The Intermediate Position 90° - 110 - Aventics RCM Mode D'emploi

56 AVENTICS | RCM | R499050098–BDL–001–AD
Commissioning
6.2 Adjusting the intermediate position system
(IP)
Intermediate position bolt screwed in too far
Malfunctions and damage to the rotary compact module may
occur if the intermediate position bolt has been screwed in
too far.
Observe the following notes on the reach of the screw
O
L for the intermediate position bolts.
min.
Maintain the permissible tightening torque M
O
nut (see Table 7 on page 57 and Table 8 on page 58).
Change the sealing rings after every tenth tightening.
O
6.2.1 Adjusting the intermediate position 70° – 90°
Information on the wrench size SW and tightening torque M
can be found in Table 7 on page 57.
1. Only apply compressed air (1) to connection C.
2. Loosen the lock nut (2) for the intermediate position bolt (3)
at connection B.
3. Unscrew the intermediate position bolt (3) up to the stop.
4. Loosen the lock nut (4) for the intermediate position bolt (5)
at connection A.
5. Adjust the intermediate position bolt (5) to the desired
intermediate position.
6. Fasten the intermediate position bolt (5) uand retighten the
lock nut (4).
7. Screw the intermediate position bolt (3) back in until no
angle play can be felt by hand at the rotary flange.
Screwing the intermediate position bolt in too far will result
in multiple intermediate positions.
NOTICE
for the lock
A
A