Table des Matières
Publicité
GB
TRANSPORTING
Do not transport with cutting mechanism rotating.
Operate the machine with due consideration of road
and surface conditions, inclines and local undulations.
LEAVING THE OPERATING POSITION
Park the machine on level ground. Before leaving the
operating position, stop the engine and make sure all
moving parts are stationary. Disengage all drives.
When the machine is to be parked, stored or left
unattended, lower the cutting units unless the
transport locks are being used.
SLOPES
TAKE EXTRA CARE WHEN WORKING ON
SLOPES
Local undulations and sinkage will change the general
slope. Avoid ground conditions which can cause the
machine to slide. Keep machine speeds low on
slopes and during tight turns.
Ratchet driven machines free-wheel on downhill
slopes. Remember there is no such thing as a "safe"
slope. Travel on grass slopes requires particular
care, to guard against overturning.
BLOCKED CUTTING CYLINDER
Stop the engine and make sure all moving parts are
stationary. Apply brakes and disengage all drives.
Release blockages with care. Keep all parts of the
body away from the cutting edge. Beware of energy in
the drive which can cause rotation when the blockage
is released.
Keep other people away from the cutting unit.
ADJUSTMENTS, LUBRICATION AND
MAINTENANCE
Read all the appropriate servicing instructions. Use
only the replacement parts supplied by the original
manufacturer.
When adjusting the cutting cylinders take care not to
get hands and feet trapped when rotating cylinder.
Make sure that other people are not touching the
cutting unit.
To reduce the fire hazard, keep the engine, silencer
and battery free of grass, leaves or excessive grease.
Replace worn or damaged parts for safety.
When working underneath lifted parts or machines,
make sure adequate support Is provided.
Do not dismantle the machine without releasing or
restraining forces which can cause parts to move
suddenly.
Do not alter engine speed above maximum quoted in
Engine Specification. Operating the engine at
excessive speed may increase the hazard of personal
injury.
6
Publicité
Table des Matières
