Table des Matières
Publicité
CORRECTION OF MINOR FAULTS
FAULT
Variation in the height of cut of
grass across the width of cut.
Grass is cut unevenly in wavy or
hummocky fashion.
Grass is torn off instead of being
cut cleanly.
Grass is removed entirely and the
mower labours.
Mower moves forward sluggishly.
Cuttings not entering grassbox
If thatch or matt start to appear on the green.
58
GB
REMEDY
Front rolls are not square with the bottom blade.
Make the necessary adjustments, see page 40.
Alignment of cutting cylinder has
been upset, probably through running into an
obstruction. Consult your local service centre.
Adjust the cutting cylinder to bottom blade,
see page 40 . If the grass is still not cut cleanly, the
cutters require sharpening. Backlap the cutters, see
page 42. If this does not rectify the fault consult your
local service centre.
Bottom blade is set too low. Raise
the height of cut, see page 40.
Cylinder may have run into an obstruction. Stop the
engine and clear.
Concave set incorrectly. To adjust properly.
see page 42.
Use Verti-Groom attachment * or fit comb.
Publicité
Table des Matières
