Table des Matières
Publicité
GB
GENERAL ADVICE
If any damage is apparent when delivery is made,
report the details at once to the supplier of the
machine.
After the first few hours of use the machine should be
checked to see that all nuts and bolts are tight.
Before cutting make sure the area to be cut is free
from stones, etc. as these may well damage the
cutting cylinder.
Do not put the mower away with grass cuttings left in
the box.
After using the machine apply oil with a brush to all
the cutters to prevent rusting. When using a hose to
clean the machine, do not direct onto the bearings or
the engine.
STORAGE
The machine should be thoroughly cleaned down to
remove all accumulations of grass clippings and
debris. Turn the cutting cylinder a few times to
prevent rusting.
Empty the fuel tank, turn off fuel tap.
Run the engine until all fuel in the carburettor has
been used up, clean filter bowl and tap. Whilst
engine is still warm, drain crankcase and refill with
fresh engine oil. Remove spark plug and pour in
approximately 5cc of anti-corrosive oil. Turn engine
over slowly until resistance is felt, this will ensure
both valves are fully closed to prevent moisture
entering. cover engine. Oil all pivot points, adjusting
screws and drive chains.
56
Publicité
Table des Matières
