Operating The Optional 2-Stage Permanently Attached I.v. Pole - Stryker M Série Mode D'emploi

OPERATING THE OPTIONAL 2-STAGE PERMANENTLY ATTACHED I.V. POLE

B
A
C
Figure 10 - I.V. Pole
Note
The 2-stage permanently attached I . V . pole is an option and may have been installed at either the head, foot or both ends
of the stretcher . The choice was made at the time the stretcher was purchased .
To use the 2-stage permanently attached I . V . pole:
1 . Lift and pivot the pole from the storage position and push down until it is locked into the receptacle .
2 . To raise the height of the pole, pull up on the telescoping portion (A) until it locks into place at its fully raised
position .
3 . Rotate the I . V . hangers (B) to desired position and hang the I . V . bags .
4 . To lower the I . V . pole, turn the latch (C) until section (A) lowers .
CAUTION
To avoid damage, the weight of the I . V . bags should not exceed 40 pounds .
Return To Table of Contents
1-18
Stretcher Operation
1025-009-005 REV B
Figure 11 - Detail of I.V. Pole Latch
www.stryker.com
A
C