Cover Replacement, Bottom - Stryker Isolibrium 2971 Manuel D'utilisation Et D'entretien

Surface de soutien intégré avec intouch fl27 2131 / 2141 version 4.0
Masquer les pouces Voir aussi pour Isolibrium 2971:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cover replacement, bottom

Tools required:
Zipper pull tool or equivalent
Prerequisite: Minimum of two operators are required to replace the bottom support surface cover.
Procedure:
1.
Apply the InTouch brakes.
2.
Unplug the support surface power cord (D)
3.
Disconnect the support surface integration cable (E)
4.
Make sure that the InTouch platform is flat.
5.
If powered, unplug the InTouch from the wall outlet and turn the battery switch to off.
6.
Remove the headboard and footboards.
7.
Lower all the siderails.
8.
Before turning, place a protective sheet on the surface that the support surface top cover will rest.
9.
Using two operators, turn the support surface over
10. Unsnap the four corner cover snaps.
11. Unsnap the two secure snaps at the right and left foot end corners.
12. Insert a zipper pull tool or equivalent through the hole in the zipper slider to unlock.
13. Grasp the zipper pull tool or equivalent and pull to unzip the bottom cover from the top cover (B)
page
1-35).
14. Feed the CPR release straps (C), power cord (D), and integration cable (E) through the bottom cover
on page
1-35).
15. Lift the foot box assembly slightly toward the head end and separate the two foot box Velcro® retainer straps from
the top of the foot box cover.
Note: During reinstall, make sure to align the foot box with the lines on the bottom cover.
16. Starting at the head end of the support surface, separate the six Velcro® patches from the bottom cover (F)
1-11 on page
1-36).
17. In a gentle motion, unsnap the twelve snaps and separate the Velcro® from the left and right sides of the turn
bladder (G)
(Figure 1-11 on page
www.stryker.com
Service
(Figure 1-10 on page
(Figure 1-10 on page
(Figure 1-10 on page
Figure 1-10: Bottom support surface cover
1-36).
2971-109-0 01 REV B
1-35).
1-35) from the bed.
1-35).
E E N N
(Figure 1-10 on
(Figure 1-10
(Figure
1-35

Publicité

Chapitres

Table des Matières
loading

Table des Matières