Stryker Isolibrium 2971 Manuel D'utilisation Et D'entretien page 19

WARNING (CONTINUED)
• Always perform preventive maintenance based on the usage level of the product. An increase in usage which may
include more frequent cleaning and disinfection, may adversely affect the life of the support surface.
• Always disinfect the support surface between patients, to avoid the risk of cross-contamination and infection.
• Always make sure that you wipe each product with clean water and thoroughly dry each product after cleaning or
disinfecting. Some cleaning and disinfecting agents are corrosive in nature and may cause damage to the product if
you use them improperly. If you do not properly rinse and dry the product, a corrosive residue may be left on the
surface of the product that could cause premature degradation of critical components. Failure to follow these
cleaning or disinfecting instructions may void your warranty.
• Always unplug the product power cord before cleaning or disinfecting to avoid the risk of shock.
• Do not service or perform maintenance while the product is in use.
CAUTION
• Do not allow sharp objects to come into contact with the support surface that could puncture, tear, or cut the cover.
• Do not allow sharp edges from the X-ray plate to come in contact with the support surface cover. The
recommendation is you cover the X-ray plate with a pillow case or other device before placement under the patient.
If damaged, remove the support surface cover from service immediately to prevent cross contamination.
• Do not iron, dry-clean, or tumble dry the support surface covers.
• Do not power wash the support surface.
• Always completely dry the support surface covers before storing, adding linens, or placing a patient on the surface.
• Do not over expose the covers to higher concentration disinfectant solutions as these may degrade the covers.
• Do not use accelerated hydrogen peroxides or quaternaries that contain glycol ethers as they may damage the cover
or the CPR strap print.
• Always use ESD protective equipment before opening antistatic bags and servicing electronic parts.
• Do not place unprotected circuit boards on the floor.
www.stryker.com
Summary of safety precautions
2971-109-0 01 REV B
E E N N
1-11