Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
DRAWER SLIDE REPLACEMENT
Tools Required:
• #2 Phillips Screwdriver
Procedure:
1 .
Push the drawer out to access the drawer slide screws .
2 .
Using a #2 Phillips screwdriver, remove the two screws that secure the drawer slides to the cabinet shelf .
3 .
Push the drawer in to access the drawer slide screws .
4 .
Using a #2 Phillips screwdriver, remove the two screws that secure the drawer slides to the cabinet shelf on the
opposite side .
5 .
Remove the drawer assembly from the cabinet .
6 .
Flip the drawer assembly upside down .
7 .
Using a #2 Phillips screwdriver, remove the four screws (two screws on each drawer slide) that secure the slide
to the drawer box .
8 .
Reverse steps to reinstall .
9 .
Verify proper operation of the unit before returning it to service .
BASE COVER REPLACEMENT
Tools Required:
• T27 Torx Driver
• #2 Phillips Screwdriver
Procedure:
1 .
Empty and remove the wastebasket by lifting up on both corners on the back edge until it releases from the two
knobs . Set the wastebasket aside for reinstallation .
2 .
Tilt the table on its side while keeping the drop leaf facing up .
Note: Place something on the floor to protect the bedside cabinet .
3 .
Using a T27 Torx driver, remove the four bolts that secure the column to the base assembly .
4 .
Using a #2 Phillips screwdriver, remove the four bolts that secure the wooden side panel to the base assembly .
5 .
Using a #2 Phillips screwdriver, remove the six screws that secure the base weldment to the base cover .
6 .
Reverse steps to reinstall .
7 .
Verify proper operation of the unit before returning it to service .
Return To Table of Contents
1-10
Service Information
4821-009-001 REV C
www.stryker.com
Publicité
Chapitres
Table des Matières
