Selecting Manual Or Thermostatic Mode - SBI CAMBRIDGE II Mode D'emploi

Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/17/2019 7:40:40 AM
1 - MANUAL ENGLISH

5.1.8 Selecting Manual or Thermostatic Mode

To change operating mode, press the desired mode from the Main Status Page.
Cambridge II and Osburn 3000C Pellet Stove Installation and Operation Manual
Stove Builder International Inc. | 48202 | Rev: May 31 2019 10:15AM | Uncontrolled Copy
(33 OF 91)
Operating mode
(Thermostatic or manual)
Press on the desired mode
Indicates that the stove is in manual mode.
continuously on the selected setting until it is manually modified, turned
OFF or if the stove runs out of pellets.
Indicates that the stove is in thermostatic mode. The red waves indicate
that the thermostat is calling for heat. It will heat at the selected
combustion level until the thermostat has reached room temperature
setting.
The waves will disappear once the thermostat has reached room
temperature setting. At this time the combustion level will switch into the
selected pilot mode until its cycle is completed. When thermostat calls for
heat, the icon will change for the one with waves and combustion level will
use the last setting.
It will therefore run
33
Page 40 of 864