SBI CAMBRIDGE II Mode D'emploi page 233

Report prepared for Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on
6/17/2019 7:40:40 AM
Certification Mark. [From the Cert Agreement: The term Product shall mean an Applicant's device,
equipment, material, or system that has been submitted for testing or evaluation, and found to be in
compliance with Intertek Requirements and approved for Listing.
Recognized Component - Identifies any component, part or sub-assembly, covered under the
recognition service of an NRTL (US) or a CO (Canada), and intended for use in Intertek Listed,
Intertek Classified, or Intertek Recognized products.
Standards - The Manufacturer shall have access to all the current standards/specifications for the
Listed product.
Unlisted Component – Because unlisted components are uncontrolled, and they do not fall under
a third-party follow up program, Intertek may require these components to be tested and/or
evaluated at least once annually, more often for certain components, as part of the independent
certification
process.
Use of Mark - The method of applying the Intertek Certification Mark (i.e. ink stamps, labels) must
be kept secured and must not leave the designated manufacturing plant(s) location(s) unless
authorized by Intertek. Records on the use of the mark are to be maintained. The Intertek
Certification Mark and associated product identification must be clearly visible and legible when
applied to the finished product. Products to be marked must have successfully passed the production
tests and scrutiny of the quality control personnel, determining that the product complies with the
specifications stated in this Report. Failure to comply with procedures constitutes ground for
withdrawal of Intertek authorization to use the Intertek Certification Mark.
Ordering Labels - When using Intertek supplied labels, it is the responsibility of the Applicant to
ensure that an adequate stock of labels is maintained. Label quantities in stock are indicated on all
packing slips issued by Intertek.
Modification Procedure - Intertek may approve modifications of a product based on an additional
evaluation or tests. Fees are charged for this service. If modifications are desired, such as
substituting a different material, changing the cosmetic appearance, changing the rating, altering a
component to simplify the manufacturing or improve the product, or any other change, the
following procedure must be followed:
1. Communicate to the Intertek office that issued this Report requesting an evaluation of the
modification required. Include a clear description and detailed drawings if required showing
exactly what is involved, and state your reason for wanting to make the modifications.
2. Wait until written authorization is received from Intertek complete with additional or revised
pages to be inserted into your Report. Only after written authorization is received may the
Applicant proceed with the modification.
PREQUALIFICATION AUDIT
This activity is required when a client is seeking third-party certification for ETL or WH Mark, Intertek
CCRR, US Coast Guard Approval, etc. for the first time or in a plant not previously qualified. This
includes a full assessment of the manufacturing and quality assurance program at the plant, and
developing the Quality Control Documentation (In-Plant QC Specifications) required for the listing.
Only an Engineer trained in the specific product area to develop plant quality assurance specs may
Stove Builder International Inc. | 48202 | Rev: May 31 2019 10:15AM | Uncontrolled Copy Page 820 of 864