Technical Data; Mechanical Characteristics; Electrical Characteristics - BIOTRONIK Evity 6 Manuel Technique

5 Technical Data

Mechanical Characteristics

Measurements for the housing
Device W x H x D [mm]
Single-chamber SR(-T) 48 x 40 x 6.5
Dual-chamber DR(-T) 48 x 44 x 6.5
Triple-chamber HF-T 53 x 52 x 6.5
Triple-chamber HF-T QP 53 x 53 x 6.5
Note: D = housing without header
X-ray identification
All device types receive the BIOTRONIK logo for X-ray identification. It can be found
centrally between the circuitry and the battery inside the housing and is visible on the
X-ray image.
Materials in contact with body tissue
• Housing: Titanium
• Header: Epoxy, polysulfone; IS4 seal: Silastic
• Silicone plug: Silopren or silastic
en • English
3 Mass [g]
Volume [cm ]
10 20.8
11 23.2
14 26.9
15 31.2

Electrical Characteristics

Components and input values
Electrical characteristics determined at 37°C, 500 Ω:
Circuit technology
Input impedance
Pulse form
Polarity
Electrically conductive surface
The device housing has the form of a flattened ellipsoid. The electrically conductive
area is for:
• Single and dual-chamber devices: 30 cm
• Triple-chamber devices: 33 cm
Telemetry data
• MICS frequency: 402 - 405 MHz
• Maximum power of transmission: < 25 µW (-16 dBm)
International radio certification
Devices with BIOTRONIK Home Monitoring
communication.
• Telemetry information for Australia:
This product is in compliance with the Australian "Radiocommuniations
Act 1992" and therefore it is labelled according to the "Radiocommunications
(Compliance Labelling - Devices) Notice."
• Telemetry information for Japan:
In accordance with Japanese law, this device has been assigned an identification
number under the "Ordinance concerning certification of conformity with technical
regulations etc. of specified radio equipment", Article 2-1-8.
R 202-LSE015
23
Dycostrate
> 10 kΩ
Biphasic, asymmetric
Cathodic
2
2
®
are equipped with an antenna for wireless