IMPORTANT
PARK THE SCOOTER ON SAFE AND
LEVEL GROUND.
•
Open the glovebox.
•
Make sure that the level of liquid
contained in the expansion tank
«2», is between the «MIN» and
«MAX» levels.
MIN = minimum level.
MAX = maximum level.
If not, top up the level.
TOPPING-UP
•
Remove the front cover «3» un-
screwing the two screws «4»
found on the front part and the
four screws «5» found on the
rear part.
•
Remove the filling cap «1».
IMPORTANT
PROCEED WITH CAUTION.
DO NOT DAMAGE THE TABS AND/OR
THEIR CORRESPONDING SLOTS.
129
ATTENTION
POSITIONNER LE VÉHICULE SUR UN
SOL FERME ET PLAT.
•
Ouvrir la boîte à gants.
•
S'assurer que le niveau de liqui-
de, contenu dans le vase d'ex-
pansion « 2 » est compris entre
les repères « MIN » et « MAX ».
MIN = niveau minimum
MAX = niveau maximum
Dans le cas contraire, procéder au rem-
plissage.
REMPLISSAGE
•
Déposer le tablier avant « 3 » en
dévissant les deux vis « 4 » pla-
cées dans la partie avant et les
quatre vis « 5 » placées dans le
contre-tablier.
•
Déposer le bouchon de remplis-
sage « 1 ».
ATTENTION
OPÉRER AVEC PRÉCAUTION.
NE PAS ENDOMMAGER LES LAN-
GUETTES ET/OU LES LOGEMENTS