Blackmagic Hyperdeck Setup - Blackmagic Design HyperDeck Manuel D'utilisation Et D'installation

Blackmagic HyperDeck Setup

Using HyperDeck Setup
Blackmagic HyperDeck Setup is used to change settings and update the internal software in
your HyperDeck. In addition to installing HyperDeck Setup, uncompressed 10 bit codecs are
installed for Mac and Windows.
The home page of HyperDeck Setup. If you have multiple HyperDecks
connected to your computer, you can choose between them by
clicking on the arrows at the sides of the home page
How to Update Your HyperDeck Software on Mac
1 Download and unzip the HyperDeck Setup software.
2 Open the resulting disk image and launch the HyperDeck Installer.
Follow the onscreen instructions.
3 After installing, connect a USB cable from HyperDeck to your computer.
4 Launch Blackmagic HyperDeck Setup and follow any onscreen prompt to update the
internal software in your HyperDeck. If no prompt appears, the internal software is up
to date and there is nothing further you need to do.
How to Update Your HyperDeck Software on Windows
1 Download and unzip the HyperDeck Setup software.
2 You should see a HyperDeck Setup folder containing this manual and the HyperDeck
Setup utility installer. Double-click the installer and follow the onscreen prompts to
complete the installation.
3 After installing, connect a USB cable from HyperDeck to your computer.
4 Launch Blackmagic HyperDeck Setup and follow any onscreen prompt to update the
internal software in your HyperDeck. If no prompt appears, the internal software is up
to date and there is nothing further you need to do.
Blackmagic HyperDeck Setup 21