Информация Для Разработчиков; Blackmagic Hyperdeck Ethernet Protocol; Protocol Commands - Blackmagic Design HyperDeck Manuel D'utilisation Et D'installation

Информация для разработчиков

Blackmagic HyperDeck Ethernet Protocol

The Blackmagic HyperDeck Ethernet Protocol is a text based protocol accessed by connecting
to TCP port 9993 on HyperDeck Studio models that have a built in Ethernet connection. If you
are a software developer you can use the protocol to construct devices that integrate with our
products. Here at Blackmagic Design our approach is to open up our protocols and we eagerly
look forward to seeing what you come up with!
HyperDeck Studio recorders with SSD slots use version 1.8. HyperDeck Studio Mini uses 1.11.
Indented commands below are featured in version 1.11 only.

Protocol Commands

Command
help or ?
commands
device info
disk list
disk list: slot id: {n}
quit
ping
preview: enable: {true/false}
play
play: speed: {-1600 to 1600}
play: speed: {-5000 to 5000}
play: loop: {true/false}
play: single clip: {true/false}
playrange
playrange set: clip id: {n}
playrange set: in: {inT} out: {outT}
playrange set: timeline in: {in} timeline
out: {out}
playrange clear
play on startup
play on startup: enable: {true/false}
play on startup: single clip: {true/false}
play option
play option: stop mode: {lastframe/
nextframe/black}
Command Description
Provides help text on all commands and parameters
return commands in XML format
return device information
query clip list on active disk
query clip list on disk in slot {n}
disconnect ethernet control
check device is responding
switch to preview or output
play from current timecode
play at specific speed
play at specific speed
play in loops or stop-at-end
play current clip or all clips
query playrange setting
set play range to play clip {n} only
set play range to play between:
- timecode {inT} and timecode {outT}
set play range in units of frames between:
- timeline position {in} and position {out} clear/reset play
range setting
clear/reset play range setting
query unit play on startup state
enable or disable play on startup
play single clip or all clips on startup
query play options
set output frame when playback stops
Информация для разработчиков 628