Playback - Blackmagic Design HyperDeck Manuel D'utilisation Et D'installation

Ref Output
The reference output on HyperDeck Studio Mini lets you connect an internally generated black
burst or tri-level sync signal to other video equipment if you want to synchronize other
equipment with your HyperDeck.
ETHERNET PoE+
On HyperDeck Studio Mini you can sync other video equipment
with your HyperDeck using the reference output

Playback

Playing Video with HyperDeck
1 Press the 'play' button once for instant playback and you'll see your video on the LCD,
and any displays connected to your HyperDeck's video outputs. When a clip is playing,
pressing 'play' again will loop it continuously. On HyperDeck Studio Mini, pressing play
a third time will let you loop all recorded clips.
NOTE With HyperDeck Studio Pro, you can choose to play back Ultra HD
using single link, dual link or quad link outputs. Refer to 'Ultra HD Playback on
HyperDeck Studio Pro' later in this section.
2 To skip to the next clip, press the 'next clip' button on the control panel.
3 Press 'previous clip' once to go to the start of the current clip or press twice to skip
back to the start of the previous clip.
Press the play button on your HyperDeck's control panel
to play back a clip, and press the forward or reverse skip
buttons to restart the current clip or skip to a different one
A
USB-C REF OUT HDMI OUT
REF IN REMOTE IN
01:23:47:08
1080p59.94 Card
01:23:47:08
B
SDI OUT
SDI IN
1080p59.94 Card 2
2
1080p59.94
01:23:47
Playback 10