Blackmagic Design HyperDeck Manuel D'utilisation Et D'installation page 18

Masquer les pouces Voir aussi pour HyperDeck:

Table des Matières

Les langues disponibles

To format using your HyperDeck:

Insert the media you want to format into either of the SD card or SSD slots.

Press the 'disp' or 'menu' button on your HyperDeck's control panel.

On HyperDecks that record on SSDs, turn the jog/shuttle wheel and press the set

button to select 'format SSD' on the LCD menu.

On HyperDeck Studio Mini, turn the jog/shuttle wheel and use the set button to enter

the 'record' menu on the LCD and select 'format card'.

Turn the jog/shuttle wheel clockwise to select 'format SSD' on the LCD menu.

On HyperDeck Studio Mini, the 'format card' setting is in the 'record' menu.

Select the SD card or SSD you want to format on the LCD using the jog/shuttle wheel.

Remember to press the 'set' button to confirm your selection.

Now set your desired format from the 'HFS+' or 'exFAT' options.

A warning message will appear on the LCD asking you to confirm the format. Make sure

you have backed up any important data before you confirm as this action cannot be

undone. Confirm the format by selecting 'format' for SD cards, or 'format SSD' using the

jog/shuttle wheel and pressing the 'set' button.

Format SSD 1

Set your desired format from the HFS+ or exFAT options. On HyperDeck

Studio Mini, HFS+ is labeled 'OS X Extended'

Format SSD 1 as HFS+?

Your disk's contents will be erased.

This action cannot be undone.

Confirm the format by using the jog/shuttle wheel and pressing the set button

A progress bar will show you the formatting progress. When your HyperDeck has finished

formatting, 'formatting complete' will display on the LCD. Press the 'set' button again to return

to the menu.

Record Trigger

Audio Channels

OS X Extended

Format SD 2 to OS X Extended?

This will erase all data from your card

This action cannot be undone.

Select Format

About SSDs and SD Cards

Chapitres

Table des Matières